AUGUST FEATURED PRODUCT ELECTO SITTER

Give Yourself a Gift!

Electro Sitter

Electro Sitter will replace your obsolete kiln sitter model! The Electro Sitter comes complete with an electronic controller of your choice for cone-fire or ramp/hold programming, an attached Type K thermocouple, ceramic fiber, and an electronic controller manual.

Installation is easy. The Electro Sitter will fit where the kiln sitter/timer is attached to the kiln. Simply remove the screws from the kiln sitter on the front of the kiln, then detach wires connecting to the kiln sitter. Wires will be attached to the back of the Electro Sitter exactly as they were attached to the kiln sitter terminal block. The thermocouple from the Electro Sitter goes through the kiln sitter hole and is exposed 1″ inside the kiln. Use fiber to fill space in the kiln sitter hole. After the Electro Sitter is installed, read the controller manual that came with it. When you are ready to program the controller, turn the kiln switches on high. You now have an electronically controlled kiln!

Electro Sitters may be used in any brand kiln that has a kiln sitter. The units are rated up to 50 amps, with higher amperage available at an additional charge.

Controller selections:
3K-CF – 4 user programs for ramp-hold programming and cone-fire firing schedules
V6-CF – 12 key digital controller with six user programs for ramp-hold programming and cone-fire firing schedules
RTC-1000 – 12 key digital controller with six user programs for ramp-hold programming
Genesis – Touch-screen technology for the user interface.

For more detailed information about each controller, see the Resources section.